Slicer3:Developers:Projects:QtSlicer/OpenDiscussions

This page gathers discussions about code architecture/implementation/design of the Slicer port to Qt. This page is mainly for developers as it concerns the internal/implementation part of Slicer, discussions about the interface design should be listed on the UIDesign wiki page. User feedbacks should be reported on the Usability wiki page.

• Please add your ideas/comments/remarks/feedback/suggestions/problems/... below.
• Points will be discussed during regular TCon meetings , on the Slicer developer list and/or by email.
• Decisions resulting from discussions should be tracked into the Mantis under the category: QtGUI.

Closed Issues

• Module Logic
  • Issue: Change qSlicerModuleLogic into vtkSlicerModuleLogic
  • Reporter: Alexander Yarmarkovich
  • Motivation: A lot of slicer logics already exist, using qSlicerModuleLogic implies to wrap this logics. Why not directly use the vtkSlicerModuleLogic?
  • Decision: Talked by email and over the phone during the Tuesday TCon (01/26/10). The suggestion has been accepted.
  • Result: The change has been committed on 01/28/10 (r11850, r11852, r11853, r11854)
  • Note: While new module logics must derive from vtkSlicerModuleLogic, logics deriving from vtkSlicerLogic are supported for backward compatibility reasons (the core module logics derive from vtkSlicerLogic).