Difference between revisions of "Slicer3:Developers:Projects:QtSlicer/OpenDiscussions"
From Slicer Wiki
| Line 1: | Line 1: | ||
| + | [[Slicer3:Developers:Projects:QtSlicer|QtSlicer]]← | ||
| + | =Presentation= | ||
This page gathers discussions about code architecture/implementation/design of the Slicer port to Qt. This page is mainly for developers as it concerns the internal/implementation part of Slicer, discussions about the interface design should be listed on the [http://www.slicer.org/slicerWiki/index.php/Slicer3:UIDesign#NEW.21:_QT_Interface_Design_Discussions UIDesign wiki page]. User feedbacks should be reported on the [http://www.slicer.org/slicerWiki/index.php/Slicer3:Usability#Collecting_user_feedback Usability wiki page]. | This page gathers discussions about code architecture/implementation/design of the Slicer port to Qt. This page is mainly for developers as it concerns the internal/implementation part of Slicer, discussions about the interface design should be listed on the [http://www.slicer.org/slicerWiki/index.php/Slicer3:UIDesign#NEW.21:_QT_Interface_Design_Discussions UIDesign wiki page]. User feedbacks should be reported on the [http://www.slicer.org/slicerWiki/index.php/Slicer3:Usability#Collecting_user_feedback Usability wiki page]. | ||
*Please add your ideas/comments/remarks/feedback/suggestions/problems/... below. | *Please add your ideas/comments/remarks/feedback/suggestions/problems/... below. | ||
Revision as of 17:13, 29 January 2010
Home < Slicer3:Developers:Projects:QtSlicer < OpenDiscussionsPresentation
This page gathers discussions about code architecture/implementation/design of the Slicer port to Qt. This page is mainly for developers as it concerns the internal/implementation part of Slicer, discussions about the interface design should be listed on the UIDesign wiki page. User feedbacks should be reported on the Usability wiki page.
- Please add your ideas/comments/remarks/feedback/suggestions/problems/... below.
- Points will be discussed during regular TCon meetings , on the Slicer developer list and/or by email.
- Decisions resulting from discussions should be tracked into the Mantis under the category:
QtGUI.
Open Issues
Closed Issues
- Module Logic
- Issue: Change qSlicerModuleLogic into vtkSlicerModuleLogic
- Reporter: Alexander Yarmarkovich
- Motivation: A lot of slicer logics already exist, using qSlicerModuleLogic implies to wrap this logics. Why not directly use the vtkSlicerModuleLogic?
- Decision: Talked by email and over the phone during the Tuesday TCon (01/26/10). The suggestion has been accepted.
- Result: The change has been committed on 01/28/10 (r11850, r11852, r11853, r11854)
- Note: While new module logics must derive from vtkSlicerModuleLogic, logics deriving from vtkSlicerLogic are supported for backward compatibility reasons (the core module logics derive from vtkSlicerLogic).
